WARNING!
Do not attempt to operate the Robocolor II Heads without the Robocolor II Controller
(e.g. plugging the Robocolor II directly into the mains outlet)
as damage may occur to the units.
Before attempting any of the following, ensure that the Robocolor II Controller is
disconnected from the mains supply.
Remove the 2 finger screws on the top-cover of each
Robocolor II Head
and carefully
remove the covers. The lamps can now be installed in the lamp holders. Ensure that
the lamps are pressed firmly into the lamp holders.
Replace the top-covers and tighten the finger screws. You can now install the
Robocolor
II Heads
in the desired positions. You are allowed to tilt the units ± 90 degrees from
horizontal position. Do not turn the units upside down.
For each
Robocolor II Head
plug the power cable into the dedicated socket on the
Robocolor II Controller
, and then the motor cable into the 5-pin DIN socket of the same
channel. If the
Robocolor II Controller
is a 230V model you must connect a
Robocolor II
Head
to both socket 1 and 2 or 3 and 4 as the lamps are series connected.
NOTE: Do not attempt to connect more than one
Robocolor II Head
to each of the four
output sockets.
NOTE: It is NOT recommended to pair worn lamps with new ones, or, to pair lamps of
different brands as variations in specifications may shorten the lamp life. This only
concerns the 230 V model where head1&2and3&4areseries connected.
OPERATING WITHOUT A LIGHTING CONTROLLER - STAND ALONE
You can now operate the
Robocolor II System
in the Stand Alone mode which means that
the
Robocolors
will perform a pre-programmed sequence at a pre-set speed or triggered by
sounds picked up by the microphone built into the
Robocolor II Controller
. Before applying
power to the
Robocolor II Controller
, you will need to set the DIP-switch according to the
sequence you wish to run. The sequence settings table on page 10 shows the various DIP-
switch settings for Stand Alone Sequences. E.g. switching on DIP-switch 1, 2 and 10 will
make the
Robocolor II System
perform an auto triggered stand alone sequence.
Note: Some sequence settings shown on the sequence setting table are for service use only
and should NOT be selected for light performances.
4
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals