Martin Magnum Pro 2000 User Manual download pdf (Page 8)

8 Operation

STATUS

The three LEDs on the rear panel of the smoke machine indicate the machines

status.

POWER (red):

There is power to the heater.

HEAT (red)

: The machine is heating. The LED flashes rapidly and then more

slowly as the heating cycle nears the end. It turns off when the heating element has

reached maximum temperature. The heating cycle for a cold machine takes 8 to 10

minutes.

READY (green)

: Ready to produce smoke. The HEAT and READY LEDs can be

on simultaneously as smoke production is possible when the machine is heating.

MANUAL OPERATION

As soon as the green READY LED turns on, you can make smoke by pressing the

Smoke button on the control unit. The output level can be adjusted using the Smoke

output knob.

Though the fluid pump stops when you release the Smoke button, smoke emission

will continue for another few seconds because the fluid in the heating element is

under pressure.

AUTO-TIMER

The auto-timer allows you to program output duration and level at repeatable

intervals. The maximum programmable interval (output duration + pause) is

approximately 1 hour.

The auto-timer sequence is stored in the smoke machine’s memory and is not

cleared when disconnecting the machine from mains power. When switched on, the

machine will execute the auto-timer sequence as soon the machine is ready.

Adjusting the smoke output potentiometer does not override the stored auto-timer

level. You can still produce smoke manually and, if this level is higher than the

stored level, it will take precedence.

To set the auto-timer

1 Adjust the Smoke output knob to the desired level.

2 Press the smoke button for the desired output duration.

3 Wait for the desired pause time and then press the timer store button.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Martin Magnum Pro 2000 User Manual Page 8