Martin RoboScan Pro 918 Specifications download pdf (Page 17)

RoboScan Pro 918

section 5

BASIC SERVICE AND MAINTENANCE

The RoboScan Pro 918 operates under challenging conditions presented by heat, humidity, dust, and touring. It

requires regular cleaning and lubrication to keep performing at its peak. The maintenance schedule will depend heavily

on the application and should be discussed with your Martin technician. This section describes basic maintenance.

Refer any service procedure not described here to a qualified technician.

IMPORTANT!

Excessive dust, grease, and smoke fluid buildup degrades performance and

causes overheating and damage to the fixture that is not covered by the war-

ranty. If you do not feel completely competent to perform the service, consult

qualified service personnel.

CCESSING

PARTS

WARNING!

Disconnect the fixture from AC power before removing any cover.

Effects section

Disconnect the fixture from AC power.

Turn the locking pins (A) on the back plate 1/2 turn.

Pull the cover back and off.

To replace the cover, position the rails on the cover in

the grooves and slide the cover forward. Push the

locking pins (A) all the way in to lock.

Printed circuit board

Disconnect the fixture from AC power.

Remove the 4 screws (B) from the front cover plate

the printed circuit board. Removing the wires is not necessary for most service procedures.

Thread the screws carefully when replacing the cover. Aluminum threads are easily stripped if screws are

overtightened or cross-threaded.

Ballast, transformer, and mains filter fuse

The ballast (E), transformer (F), and mains filter circuit

board (G) are accessed by removing the cover (D) from the

top of the RoboScan Pro 918.

Disconnect the fixture from AC power.

Remove the 4 screws from the plastic ballast/trans-

former cover (D) and lift it off.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 30 31

No comments

Martin RoboScan Pro 918 Specifications Page 17