Martin MAC 401 Dual User Manual download pdf (Page 13)

Setup 13

Setup

Warning! Read “Safety Information” on page 3 before installing, powering, operating or servicing

the MAC 401 Dual™.

Control panel and menu navigation

The onboard control panel and LED display are used to set the MAC 401 Dual™’s DMX address, configure

individual fixture settings (personality), read out data and execute service utilities. See “Onboard control

menus” on page 30 for a complete list of menus and commands.

Using the control buttons

See Figure 4.

• Press [Menu] to enter a menu, to escape a function or move back one level in the menu structure.

• Press the [Up] and [Down] buttons to scroll within a menu or increase and decrease values.

• Press [Enter] to enter a submenu or activate a function. Note: [Enter] must be pressed and held for a few

seconds to enter the Service menu (

SERV).

Control menu shortcuts

• Hold [Menu] and press [Up] - Resets fixture

• Hold [Menu] and [Enter] during fixture reset - Freezes pan and tilt

• Hold [Up] and press [Down] - Inverts display for easy reading when the fixture is suspended base up.

Display functions

The DMX address is shown in the display panel when the MAC 401 Dual™ is powered on and has reset.

By default the display is set to go into to sleep mode 2 minutes after the last key press. To reactivate the

display, press any key. To modify or disable this setting see “Display settings” on page 16.

Figure 4: Control panel and display

A B C

A – Four-character LED display

B – Service indicator LED

C – DMX input indicator LED

D – UP button

E – ENTER button

F – DOWN button

G – MENU button

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

No comments

Martin MAC 401 Dual User Manual Page 13