Martin Atomic Colors User Manual download pdf (Page 14)

OPERATING THE UNIT

All user settings are accessed using the LED display and the three push buttons on the side panel.

Powering up the system

When you power up the system, the following things happen:

• The gel string moves from one end to the other to determine the length of the string installed.

• The LED display shows the unit’s control address. After 5-7 seconds, the display switches to

monitor mode.

• If the unit is receiving DMX data, the gel string then moves to a position determined by the

control signal.

The Atomic 3000DMX strobe may begin to flash, depending on the way it is set up and the value

of the DMX signal that the unit is receiving.

Push Button Operation:

Use the ‘ACTION/RECALL’ button to scroll through the different modes of operation. Use the

‘UP’ or ‘DOWN’ buttons to select values in that mode. When a mode or value is changed, the last

display character will flash until the

‘ACTION/RECALL’ button is pushed to acknowledge (or

record) the change. The new setting takes effect the next time the unit is powered up.

Display Operation:

Control Function

‘ACTION/RECALL’

Mode access and ‘Record’

‘DOWN’

Decrements the mode level, or value

‘UP’

Increments the mode level, or value

3 digit display

Displays modes, monitor, or blank display.

Power-up Display

On power-up, the display will show the DMX address.

Atomic Colors User Manual Operating the unit 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

No comments

Martin Atomic Colors User Manual Page 14