Martin Magnum 1800 User Manual download pdf (Page 19)

Basic service 19

Basic service

Before servicing the Magnum smoke machine, read and observe all the

precautions listed in “Safety information” on page 3. Any service not described in

this section must be carried out by a Martin service technician.

Cleaning

Excessive dust, smoke fluid, and dirt build-up will degrade performance and

cause overheating and damage to the machine that is not covered by the

product warranty. To maintain adequate cooling, dust must be cleaned from the

outer casing and air vents of the machine periodically.

Isolate the machine from power and allow to cool completely before cleaning.

The smoke output nozzle remains hot for up to 10 hours after use.

• Remove dust from the air vents with a soft brush, cotton swab, vacuum,

or compressed air.

• Clean smoke fluid residues from the fog output of the machine using a

damp cloth.

• Clean the outer casing with a damp cloth only.

Fuse replacement

The main fuse for the Magnum smoke machine is located on the electronics

board inside the unit.

DANGER! Disconnect the power supply before removing any covers. Live parts

inside!

To replace the fuse, disconnect the power cord from the supply, unscrew the

screws holding the top cover of the unit and remove the cover. The electronics

board is located at the back of the unit near the remote control sockets.

Remove the fuse holder cover and pull out the fuse. Remove the spent fuse and

replace with one of exactly the same size and rating. The fuse type is indicated

below. Contact Martin Service if the fuse blows repeatedly.

Magnum 1800

120V = 10AT

230V = 6.3AT

Magnum 1200

120V = 10AT

230V = 5AT

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

Martin Magnum 1800 User Manual Page 19