5Setup
section 2
SETUP
This section describes the steps required to prepare the SynchroZap for operation.
Unpacking
The SynchroZap QX250 comes with:
• 5-meter, 3-pin shielded XLR control cable
• 1.5-meter, 3-wire IEC power cable
•user manual
The packing material is carefully designed to protect the fixture during shipment - always
use it to transport the fixture.
Installing or changing the lamp
The SynchroZap QX250 is designed to use the Philips MSD-200 or MSD-250/2 discharge
lamp. Installing other lamps may damage the fixture.
For maximum light output, use the MSD-250/2 lamp.
data output
data input
S/N label
lamp assembly
access plate
lamp adjustment
bracket
mains input
fuse holder
tilt lock (2)
DIP switch
Figure 1: Rear view
screw (2)
screw (3)
Comments to this Manuals