Martin MAC 350 Entour User Manual download pdf (Page 10)

10 MAC 350 Entour user manual

• Connect one AC power phase to the terminal marked N or Phase 1 or L1.

• Connect another AC power phase to the terminal marked L or Phase 2 or L2.

Installing the male power input connector on a cable

To attach a power cable to the supplied input connector:

1. Slide the bushing over the cable.

2. Slide the white chuck over cables with a diameter (D

) of 5 - 10 mm

(0.2 - 0.4 in.), or the black chuck over cables with a diameter of 10 -

15 mm (0.4 - 0.6 in.).

3. Prepare the end of the cable by stripping 20 mm (0.8 in.) of the

cable’s outer jacket.

4. Strip 8 mm (1/3 in.) from the end of each of the wires.

5. Insert each of the wire ends into the appropriate terminal (see

instructions and Table 1 above) and fasten the clamping device

using a small flathead screw driver.

6. Push and insert the chuck into the housing (note that there is a

raised key on the chuck to ensure that it is oriented correctly).

7. Fasten the bushing, using a wrench, to a torque of 2.5 Nm (1.8

lb.-ft).

Illustrations above used by kind permission of Neutrik AG.

Mains fuses

WARNING! Replace fuses with ones of the same type and rating only.

WARNING! Double-pole/neutral fusing.

The MAC 350 Entour is protected by two 10 amp slow-blow mains fuses located in fuseholders next to the

power input connector. See “Fuse replacement” on page 29 for details of accessing and changing the fuse.

Applying power

WARNING! Do not apply AC mains power to the fixture at any other voltage than that specified on

the fixture’s serial number label.

MAC 350 Entour™ fixtures are factory-configured to accept AC mains power at 100-240 V nominal, 50/60

Hz.

Check that power cables are undamaged and rated for the current requirements of all connected devices.

Plug the fixture’s power cable into the fixture’s Neutrik PowerCon socket and a grounded (earthed) source of

AC power.

Important! Do not supply the fixture with power from a dimmer system, as this may cause damage that is not

covered by the product guarantee.

Chuck BushingHousing Insert

Cable end

Terminals

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

No comments

Martin MAC 350 Entour User Manual Page 10