Martin MAC 350 Entour User Manual download pdf (Page 9)

AC power 9

AC power

WARNING! Read “Safety Information” starting on page 3 before connecting the MAC 350 Entour to

AC power.

For protection from electric shock, the MAC 350 Entour must be grounded (earthed). The power

distribution circuit must be equipped with a fuse or circuit breaker and ground-fault (earth-fault)

protection.

The MAC 350 Entour does not have a power on/off switch. To shut down power urgently, disconnect

the fixture’s power input connector.

Important! Do not use an external dimming system to supply power to the MAC 350 Entour as this

may cause damage to the fixture that is not covered by the product warranty.

The MAC 350 Entour can be hard-wired to a building electrical installation if you want to install it

permanently. If you do this, provide a means of shutting down power near the fixture. Alternatively a power

cable (not supplied) with a power plug suitable for local power output sockets can be used to supply the

fixture with AC mains power.

The MAC 350 Entour can be supplied with AC mains power by connecting to one of the following three-wire

systems:

• single-phase AC mains power system (live, neutral, ground/earth) at 100-240 V, 50/60 Hz, or

• two phases of a 3-phase delta or split-phase mid-point neutral AC mains power system (phase, phase,

ground/earth) to obtain 200-240 V, 50/60 Hz.

Power cable and plugs

The fixture must be connected to AC power using three-conductor cable that is rated 10 A minimum (16

AWG or 1.5 mm

). The cable jacket must be SJT type or better and heat-resistant to 90° C (194° F)

minimum. A power cable is not supplied with the product.

The MAC 350 Entour™ is supplied with a male Neutrik PowerCon NAC3FCA locking 3-pole input connector

that can be installed on the power cable for power input to the fixture.

If you decide to install a power plug on the fixture’s power cable, install a grounding-type (earthed) plug that

is correctly rated for the current and power requirements of the fixture. Follow the plug manufacturer’s

instructions. Table 1 shows standard wire color-coding schemes and some possible pin identification

schemes; if pins are not clearly identified, or if you have any doubts about proper installation, consult a

qualified electrician.

When installing a plug on a power cable that will be connected to a single-phase AC mains power system at

100-240 V, 50/60 Hz:

• Connect the ground (earth) conductor to the terminal marked

or .

• Connect the neutral conductor to the terminal marked N.

• Connect the live conductor to the terminal marked L.

When installing a plug on a power cable that will be connected to two phases of a 3-phase delta or

split-phase mid-point neutral system to obtain 200-240 V, 60 Hz AC mains power:

• Connect the ground (earth) conductor to the terminal marked or .

Wire Color (EU) Wire Color (US) Conductor Symbol Screw (US)

brown black live L yellow or brass

blue white neutral N silver

yellow/green green ground (earth) or green

Table 1: Wire color-coding and power connections

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Comments to this Manuals

No comments

Martin MAC 350 Entour User Manual Page 9

Comments to this Manuals

Related products and manuals for Floodlights Martin MAC 350 Entour