Martin MAC 401 Dual User Manual download pdf (Page 30)

30 MAC 401 Dual

™

user manual

Onboard control menus

Single head module operation

When only one module is installed on the head and the HEAD menu is set to SNGL, the following control

menus are available:

Menu Item Options Notes (Default settings in bold print)

ADDR

– XXX

DMX address (default address = 1). The DMX address range is limited

so that the fixture will always have enough DMX channels in the 512

available.

DMX

PSET

RGBX

RGB mode with dynamic effects

HSX

HSV mode with dynamic effects

RGB

RGB mode without dynamic effects

HSV mode without dynamic effects

PGRP

Individual control of 4 pixels (segments)

Control of pixels in 2 groups of 2 pixels, horizontal split

Control of pixels in 2 groups of 2 pixels, vertical split

All

All pixels controlled as one group

PINV

OFF

Disable pixel inversion

Pixel inversion: pixels swapped left to right and top to bottom

PERS

PTST

PTSP

Pan and tilt speed normal / fast / slow

SWAP

Swap pan and tilt (pan commands move tilt and vice versa) - off / on

PINV

Pan inversion (reverse direction pan control) - off / on

TINV

Tilt inversion (reverse direction tilt control) - off / on

FANS

REG

Cooling fan speed thermostatically regulated

FULL

Max. cooling fan speed

SLNT

Silent mode. When Silent mode is selected the head fan will turn off.

The base fan will still run. Values allowed for RGB or HSV (no matter

what operating mode) will be limited to prevent the fixture from

producing too much heat. If the LEDs get too hot the fans will revert to

Regulated mode. When the LEDs are cool enough the fans shift back to

Silent mode. The color wheel channel will have lower intensity in Silent

mode.

DIM

LIN

Linear dimming curve

SQR

Square law dimming curve

ISQR

Inverse square law dimming curve

SCUR

S-curve dimming curve

DRES

OFF

Disable reset via DMX

Enable reset via DMX

DISP

Display is always on

2MN

Display switches off and goes into Sleep mode if the controls have

not been pressed for 2 minutes.

5MN

Display switches off and goes into Sleep mode if the controls have not

been pressed for 5 minutes

10MN

Display switches off and goes into Sleep mode if the controls have not

been pressed for 10 minutes

DINT 0-100

Display intensity. Default=100

ERRM

NORM

Display errors at 100% intensity (regardless of DINT setting) and

illuminate the service light.

SLNT

Silent error mode. The error message does not appear in the display,

but the service lamp is illuminated

CTC

WITH

Sending a value on a CTC channel adjusts the temperature of

whatever color is currently being displayed on segment or fixture

INDP

Sending a value on a CTC channel overrides any color being displayed.

Fixture or segment switches to white with variable color temperature

FACT

FACT LOAD

Return all settings (except calibrations) to factory defaults

NB: can take up to 2 minutes to complete!

CUS1,

CUS2,

CUS3

LOAD

Load custom configuration

SAVE

Save current custom configuration

Table 4: Control menu: single head module operation

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Comments to this Manuals

No comments

Martin MAC 401 Dual User Manual Page 30

Comments to this Manuals

Related products and manuals for Floodlights Martin MAC 401 Dual