Martin MAC 401 Dual User Manual download pdf (Page 32)

32 MAC 401 Dual

™

user manual

Dual head module operation

When you install a second head module on the rear of the head and select DUAL in the HEAD menu,

you have two menus available to you in the control panel:

FRNT or REAR.

• If the

FRNT menu is selected, all the commands you enter are applied to the fixture and the front head

module.

• If the

REAR menu is selected, all the commands you enter are applied to the fixture and the rear head

module. Note that the PERS, FACT, DMXL and SERV menus are only available in the REAR

menu.

FRNT MENU

Menu Item Options Notes (Default settings in bold print)

ADDR

– XXX

DMX address (default address = 1). The DMX address range is limited

so that the fixture will always have enough DMX channels in the 512

available.

DMX

PSET

RGBX

RGB mode with dynamic effects

HSX

HSV mode with dynamic effects

RGB

RGB mode without dynamic effects

HSV mode without dynamic effects

PGRP

Individual control of 4 pixels (segments)

Control of pixels in 2 groups of 2 pixels, horizontal split

Control of pixels in 2 groups of 2 pixels, vertical split

All

All pixels controlled as one group

PINV

OFF

Disable pixel inversion

Pixel inversion: pixels swapped left to right and top to bottom

INFO

VERS

MAIN

CPU firmware version in main processor

HEAD

CPU firmware version in head processor front module / rear module (if

installed)

pOHR

RSET

Hours of operation since counter reset (to reset counter, display counter

and press [Up] for 5 secs.)

TOTL

Total hours of operation since manufacture

MTMP

CURR

Display current main PCB temperature

MSR

Display highest main PCB temperature since last reset

Display highest main PCB temperature since manufacture

DTMP

CURR

Display current average driver PCB temperature

MSR

Display highest driver PCB temperature since last reset

Display highest driver PCB temperature since manufacture

PTMP

CURR

Display current average pixel PCB temperature

MSR

Display highest pixel PCB temperature since last reset

Display highest pixel PCB temperature since manufacture

AIRF

TOTL

Current elapsed time in hours since the air filter was cleaned or

changed. Display the counter and press the up button for five seconds

to reset it.This counter must be reset manually when the air filter is

cleaned.

STTM

Set duration of time alert to be issued after 100-9999 hours have

passed on the

TOTL counter, to remind you to clean it, particularly the

air filter. The alert appears as long as the value of the

TOTL counter

is higher than the threshold set here.

SNUM

RDM

Display fixture’s RDM ID

SNUM

Display fixture’s serial number

Table 5: Control menu: dual head module operation, FRNT menu

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments

Martin MAC 401 Dual User Manual Page 32

Comments to this Manuals

Related products and manuals for Floodlights Martin MAC 401 Dual