Martin EFX700 User Manual download pdf (Page 34)

34 Mania SCX600/700 user manual

6. T

ROUBLESHOOTING

Problem Probable cause(s) Remedy

One or more fixtures is

completely dead.

No power to fixture. Check that power is switched

on and cables are plugged in.

Main fuse blown. Replace fuse.

Fixtures reset correctly but all

respond erratically or not at

all to controller.

Controller not connected. Connect controller.

XLR pin-out of controller

does not match pin-out of

first fixture on link (i.e.

polarity is reversed).

Install a phase-reversing

cable between controller and

first fixture on link.

Fixtures reset correctly but

some respond erratically or

not at all to controller.

Bad data link connection. Inspect connections and

cables. Correct poor

connections. Repair or

replace damaged cables.

Data link not terminated with

120 Ohm termination plug.

Insert termination plug in

output of last fixture on link.

Incorrect fixture addressing. Check DMX addresses.

One of the fixtures is

transmitting as a master.

Check all fixture settings.

One of the fixtures is

defective.

Bypass one fixture at a time

(unplug both DMX

connectors and connect

them directly together) until

normal operation is regained.

Have defective fixture

serviced by a Martin

technician.

A number appears in display

and fixture will not run a

stand-alone light show.

Fixture is set to DMX mode

and is displaying its DMX

address.

Use control panel to change

fixture from DMX to stand-

alone auto trig or music trig.

An effect fails to reset

correctly.

The effect may require

mechanical adjustment.

Contact Martin technician for

service.

Lamp cuts out intermittently

or burns out too quickly.

Fixture is too hot. Allow fixture to cool.

Check that there is free

airflow around the fixture.

Check, and if necessary

clean, fan and grills.

Fixture does not respond

correctly to music beat in

music trig mode.

Music level sensitivity is

incorrectly adjusted.

Use control panel to adjust

sensitivity until fixture

responds satisfactorily.

SCX700: Impossible to

restrike lamp after dousing

via DMX or powering off.

8-minute restrike protection

delay activated or lamp too

hot to strike.

Wait 8 minutes before

restriking a hot discharge

lamp.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

Comments to this Manuals

No comments